Home › ENGINE · 3ZR-FAE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


    A205217E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      11.6 to 12.4 Ω

      Text in Illustration 
      *1
      Component without harness connected
      (Fuel Injector Assembly)
      If the result is not as specified, replace the injector assembly.



  1. Check the injection volume.

    CAUTION:
    1. Perform the inspection in a well-ventilated area.
    2. Do not perform the inspection near any naked flames.




      A159425E07
    1. Connect SST (fuel tube connector) to SST (hose), and then connect them to the fuel pipe (vehicle side).

      SST
      09268-31012   (90467-13001, 95336-08070, 09268-41500)
      Text in Illustration 
      *1
      SST (Hose)
      *2
      Fuel Pipe
      *3
      SST (Clip)
      *4
      SST (Fuel Tube Connector)
      *5
      Retainer
      *6
      O-Ring



    2. A129474E10
    3. Install the O-ring onto the fuel injector assembly.

    4. Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).

      SST
      09268-31012   (09268-41110, 90467-13001, 95336-08070, 09268-41300)
      Text in Illustration 
      *1
      SST (Clip)
      *2
      SST (Adapter)
      *3
      SST (Hose)
      *4
      O-Ring
      *5
      SST (Clamp)
      *6
      Vinyl Tube

    5. Install a vinyl tube onto the injector.

      CAUTION:
      Install a suitable vinyl tube onto the injector to prevent gasoline from splashing out.

    6. Put the injector into a graduated cylinder.

    7. Operate the fuel pump .



    8. A075915E10
    9. Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30080  

      Injection Volume:
      60 to 73 cc (3.7 to 4.5 cu. in.) per 15 seconds

      Difference between each injector:
      13 cc (0.8 cu. in.) or less

      NOTICE:
      Always do the switching at the battery side.

      If the injection volume is not as specified, replace the injector assembly.



    A132391
  1. Inspect for fuel leak.

    1. In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leaks from the injector.

      Standard:
      1 drop or less every 12 minutes