AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Air conditioning system data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform troubleshooting.
| CHECK DLC3 |
![]() |
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG(5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 10 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch off* | 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch off* | 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Ignition switch off* | 1 MΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch off* | 200 Ω or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Ignition switch off* | 1 MΩ or higher |