Home › ENGINE · 1AZ-FE › STARTING › STARTER RELAY

STARTER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE STARTER RELAY
  1. for LHD:
    Remove the starter relay from the No. 7 relay block.

  1. for RHD:
    Remove the starter relay from the No. 8 relay block.



3. INSPECT STARTER RELAY


    B060778E26
  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the resistance is not as specified, replace the relay.



4. INSTALL STARTER RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL