Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING

FRONT DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


B129158
  1. Using a screwdriver, detach the clip, 3 claws and remove the garnish.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT ARMREST BASE PANEL UPPER LH


B129159
  1. Using a screwdriver, detach the clip, 5 claws, and remove the panel (with the switch).

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the switch connectors.



    B129161
  1. for Driver Side:
    Remove the 3 screws and power window regulator master switch from the panel.

    NOTICE:
    Be careful when removing the screws as the switch may fall and become damaged.



    B139756
  1. for Passenger Side:
    Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.

    HINT:
    Tape the screwdriver tip before.

    NOTICE:
    Be careful when detaching the claws as the switch may fall and become damaged.



3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


B129165
Using a screwdriver, detach the 12 claws and remove the door assist grip.

HINT:
B129164
Tape the screwdriver tip before use.
Using a screwdriver, detach the 3 claws and remove the door inside handle plug.

HINT:
Tape the screwdriver tip before use.



    B129166
  1. Remove the 3 screws.

  1. Using a screwdriver, detach the 10 clips, 2 claws and remove the trim.

    HINT:
    1. Tape the screwdriver tip before use.
    2. If the screwdriver cannot reach the clips, pull on the lower trim to remove it.

  1. Using a screwdriver, detach the 7 claws and remove the weatherstrip inner.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a screwdriver, detach the 4 claws and remove the speaker door grille.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


B129405E01
  1. Disconnect the mirror connector labeled A.

  1. Remove the 3 screws.

  1. Remove the outer rear view mirror.



5. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH


    B130251
  1. Put protective tape under the belt moulding.

  1. Using a moulding remover, detach the claws to remove the belt moulding as shown in the illustration.

    HINT:
    Tape the remover tip before use.

    NOTICE:
    Be careful when removing the belt moulding as there are claws attached to the front and rear ends of the belt moulding.