Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH


    B130255
  1. Attach the claws to install the moulding.

    HINT:
    Confirm that the moulding is firmly installed.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Attach the 6 claws to install the weatherstrip inner.



    B133485
  1. Attach the 2 claws to install the inside handle.



    B137875E02
  1. for 8 Clip Type:
    Attach the 8 clips to install the trim board.

  1. for 7 Clip Type:
    Attach the 7 clips to install the trim board.

  1. Install the 3 screws.



    B129164
  1. Attach the 3 claws to install the door inside handle bezel plug.



    B130017
  1. Attach the 12 claws to install the door assist grip cover.



3. INSTALL REAR DOOR ARMREST BASE PANEL UPPER LH


    B133495
  1. Attach the 2 claws and install the power window regulator switch to the panel.

  1. Connect the switch connector.



    B133496
  1. Attach the clip and 5 claws to install the panel (with the switch).