REAR DOOR BELT MOULDING > REMOVAL |
| 1. REMOVE REAR DOOR ARMREST BASE PANEL UPPER LH |
![]() |
Using a screwdriver, detach the clip, 5 claws, and remove the panel (with switch).
Disconnect the switch connectors.
![]() |
Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.
| 2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Using a screwdriver, detach the 12 claws and remove the door assist grip cover.
![]() |
Using a screwdriver, detach the 3 claws and remove the door inside handle bezel plug.
![]() |
Remove the 3 screws.
for 8 Clip Type:
Using a screwdriver, detach the 8 clips, 2 claws and remove the trim.
for 7 Clip Type:
Using a screwdriver, detach the 7 clips, 2 claws and remove the trim.
Using a screwdriver, detach the 6 claws and remove the weatherstrip inner.
| 3. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH |
![]() |
Put protective tape under the belt moulding.
Using a moulding remover, detach the claws to remove the belt moulding as shown in the illustration.