INPUT SHAFT > INSPECTION |
| 1. INSPECT INPUT SHAFT |
![]() |
Using V-blocks and dial indicator, measure the shaft for runout.
![]() |
Using a micrometer, measure the diameter of the input shaft journal surface.
| Journal Position | Specified Condition |
| A | 35.984 to 36.000 mm (1.4167 to 1.4173 in.) |
| B | 35.984 to 36.000 mm (1.4167 to 1.4173 in.) |
| C | 27.957 to 27.972 mm (1.1007 to 1.1013 in.) |
| Journal Position | Specified Condition |
| A | 35.984 mm (1.4167 in.) |
| B | 35.984 mm (1.4167 in.) |
| C | 27.957 mm (1.1007 in.) |
| 2. INSPECT 4TH GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 4th gear.
| 3. INSPECT 3RD GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter.
| 4. INSPECT 2ND SYNCHRONIZER OUTER RING |
![]() |
Coat the 4th gear cone with gear oil. Turn the 2nd synchronizer outer ring (synchronizer ring No. 4) in one direction while pushing it against the 4th gear cone. Check that the ring locks.
If the 2nd synchronizer outer ring does not lock, replace the ring or the 4th gear.
![]() |
Using a feeler gauge, measure the clearance between the 2nd synchronizer outer ring (No. 4 synchronizer ring) back and 4th gear spline end.
| 5. INSPECT NO. 3 SYNCHRONIZER RING |
![]() |
Coat the 3rd gear cone with gear oil. Turn the No. 3 synchronizer ring in one direction while pushing it against the 3rd gear cone. Check that the ring locks.
If the No. 3 synchronizer ring does not lock, replace the ring or the 3rd gear.
![]() |
Using a feeler gauge, measure the clearance between the No. 3 synchronizer ring back and 3rd gear spline end.
| 6. INSPECT NO. 2 TRANSAXLE HUB SLEEVE |
![]() |
Inspect the sliding condition between the No. 2 transaxle hub sleeve and No. 2 transaxle clutch hub.
Inspect the tip of the spline gear on the No. 2 transaxle hub sleeve for wear.
If any defects are found, replace the transaxle hub sleeve or the transaxle clutch hub.
![]() |
Using vernier calipers, measure the width of the No. 2 transaxle hub sleeve groove (A) and the thickness of the claw part on the No. 2 gear shift fork (B), and calculate the clearance.