Home › TRANSMISSION ยท E352 MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER


C068517E01
  1. Using a micrometer, measure the thickness of the thrust washer.

    Minimum thickness:
    0.9 mm (0.035 in.)

    If the thickness is less than the minimum, replace the thrust washer.



2. INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT


C068518E01
  1. Using a micrometer, measure the outside diameter.

    Minimum diameter:
    17.975 mm (0.70768 in.)

    If the outside diameter is less than the minimum, replace the No. 1 differential pinion shaft.