Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › SECOND BRAKE PISTON

SECOND BRAKE PISTON > REASSEMBLY

for Preparation Click here



1. INSTALL 2ND BRAKE PISTON O-RING


    D026706E02
  1. Coat 2 new O-rings with ATF, and install them in the 2nd brake piston.

    NOTICE:
    Make sure that the O-rings are not twisted or pinched.



2. INSTALL 2ND BRAKE PISTON


    D026775E01
  1. Coat the 2nd brake piston with ATF, and install it to the 2nd brake cylinder.

    NOTICE:
    Be careful not to damage the O-rings.



3. INSTALL 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY


    D026704E04
  1. Install the 2nd brake piston return spring.

    NOTICE:
    After installing the spring, check that all of the springs fit in the piston correctly.



    D026703E02
  1. Place SST on the piston return spring, and compress the piston return spring with a press.

    SST
    09387-00060  

  1. Using a screwdriver, install the snap ring.

  1. Make sure that the end gap of the snap ring is not aligned with the spring retainer claw.

    NOTICE:
    Stop the press when the spring seat is lowered to a position 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove. This prevents the spring seat from being deformed.