DTC B1442/42 Air Inlet Damper Control Servo Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1442/42 | Air inlet damper position does not change even if air conditioning amplifier operates air inlet damper control servo motor |
|

| 1.READ VALUE USING INTELLIGENT TESTER (A/I DAMP TARG PLS) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.
Select the items below in the Data List, and read the value displayed on the intelligent tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| A/I Damp Targ Pls | Air inlet damper target pulse / for LHD Min.: 7, Max.: 19 for RHD Min.: 7, Max.: 25 | for LHD
for RHD
| - |
| Result | Proceed to |
| NG | A |
| OK (Checking from PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR INLET CONTROL SERVO MOTOR |
|
| ||||
| OK | ||
| ||