DTC B1451/51 Compressor Solenoid Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1451/51 | Open or short in solenoid of externally changeable compressor circuit |
|

| 1.READ VALUE USING INTELLIGENT TESTER (REG CTRL CURRNT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.
Select the items below in the DATA LIST, and read the value displayed on the intelligent tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Regulator Control Current | Regulator control current / Min.: 0 A Max.: 0.997 A | Value changes between 0 A and 0.997 A in accordance with A/C compressor operation | - |
| Result | Proceed to |
| NG | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT A/C COMPRESSOR |
![]() |
Disconnect the A/C compressor clutch connector.
Measure the resistance of the connector.
| Tester Connection | Condition | Specified Condition |
| 1 (SOL-) - 2 (SOL+) | 25°C (77°F) | 10.1 to 11.1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (A/C COMPRESSOR - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the B23 or B40 A/C compressor connector.
Disconnect the E41 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| B23-2 (SOL+) - E41-2 (SOL+)(*1) | Below 1 Ω |
| B23-2 (SOL+) - Body ground(*1) | 1 MΩ or higher |
| B40-2 (SOL+) - E41-2 (SOL+)(*2) | Below 1 Ω |
| B40-2 (SOL+) - Body ground(*2) | 1 MΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (A/C COMPRESSOR - BODY GROUND) |
![]() |
Disconnect the B23 or B40 A/C compressor connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| B23-1 (SOL-) - Body ground(*1) | Below 1 Ω |
| B40-1 (SOL-) - Body ground(*2) | Below 1 Ω |
|
| ||||
| OK | ||
| ||