Home › ENGINE · 1AZ-FE › ENGINE CONTROL SYSTEM › IGNITION RELAY NO. 1

IGNITION RELAY NO. 1 > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE IG1 RELAY (Marking: IG1)
  1. Remove the IG1 relay from the instrument panel junction block.



3. INSPECT RELAY


    A092673E14
  1. Measure resistance of the IG1 relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



4. INSTALL IG1 RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL