Home › ENGINE · 2GR-FE › ENGINE CONTROL SYSTEM › IGNITION RELAY NO. 1

IGNITION RELAY NO. 1 > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE IG1 RELAY
  1. Remove the IG1 relay from the instrument panel junction block.



3. INSPECT IG1 RELAY


    A092673E14
  1. Measure the resistance of the IG1 relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



4. INSTALL IG1 RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL