Home › BODY › WINDSHIELD / WINDOWGLASS › DEFOGGER RELAY

DEFOGGER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. INSPECT RELAY
  1. Disconnect the IG, IF and IQ junction block connectors.



  1. Measure the resistance of the Defogger relay.


    B139886E01

    Standard resistance:
    Tester Connection
    Specified Condition
    1G-1 - 1F-2
    10 kΩ or higher
    1G-1 - 1F-2
    Below 1 Ω
    (when battery voltage is applied to terminals 1Q-12 and IQ-4)

    If the result is not as specified, replace the instrument panel junction block.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL