Home › ENGINE · 3ZR-FAE › ENGINE CONTROL SYSTEM › IGNITION RELAY NO. 1

IGNITION RELAY NO. 1 > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE IG1 RELAY
  1. Remove the IG1 relay from the main body ECU.



3. INSPECT RELAY


    A092673E50
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



4. INSTALL IG1 RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL