STEERING PAD SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE STEERING PAD ASSEMBLY (for 3ZR-FAE) |
![]() |
Straighten the front wheels.
Using a thin-bladed screwdriver, push open the spring clips and disengage the pins.
![]() |
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
Using a screwdriver, disconnect the 2 airbag connectors.
Disconnect the horn connector and remove the steering pad.
| 3. REMOVE STEERING PAD ASSEMBLY (except 3ZR-FAE) |
![]() |
Straighten the front wheels.
Using a thin-bladed screwdriver, push open the spring clips and disengage the pins.
![]() |
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
Using a screwdriver, disconnect the 2 airbag connectors.
Disconnect the horn connector and remove the steering pad.
| 4. REMOVE STEERING PAD SWITCH ASSEMBLY (except 3ZR-FAE) |
w/ Navigation System (for HDD):
![]() |
Disconnect the connectors.
Remove the 2 screws.
Detach the 2 claws and remove the steering pad switch.
w/ Navigation System (for DVD):
![]() |
Disconnect the connectors.
Remove the 2 screws.
Detach the 2 claws and remove the steering pad switch.
| 5. REMOVE STEERING PAD SWITCH ASSEMBLY (for 3ZR-FAE) |
![]() |
w/ Bluetooth:
w/ Paddle Switch:
Detach the clamp and disconnect the connectors.
w/o Paddle Switch:
Disconnect connector A.
Remove the 2 screws.
Detach the 2 pins and remove the steering pad switch.
![]() |
w/o Bluetooth:
w/ Paddle Switch:
Detach the clamp and disconnect the connectors.
w/o Paddle Switch:
Disconnect connector A.
Remove the screw.
Detach the pin and remove the steering pad switch.