BRAKE PEDAL > INSTALLATION |
| 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY |
![]() |
Install the support with the 4 nuts.
![]() |
Install the bolt to the support.
| 2. INSTALL PUSH ROD PIN |


Apply lithium soap base glycol grease to the push rod pin.
Install the push rod pin to the push rod clevis.
Install a new clip to the push rod pin.
| 3. INSTALL STOP LIGHT SWITCH ASSEMBLY |
![]() |
Insert the switch into the adjuster until the switch body touches the pedal.
![]() |
Turn the switch a quarter turn clockwise.
Check the switch clearance.
| 4. CONNECT CONNECTORS |
with VSC:
Connect the brake pedal load sensing switch connector.
Connect the stop light switch connector.
| 5. CHECK AND ADJUST BRAKE PEDAL HEIGHT |
![]() ![]() |
Check the pedal height.
| Item | Specified Condition |
| for LHD | 184.2 to 194.2 mm (7.252 to 7.646 in.) |
| for RHD | 168.6 to 178.6 mm (6.638 to 7.031 in.) |
Adjust the pedal height.
Disconnect the connector from the stop light switch.
Remove the switch.
Loosen the push rod clevis lock nut.
Adjust the pedal height by turning the push rod.
Tighten the lock nut.
![]() |
Insert the switch into the adjuster until the switch body touches the pedal.
![]() |
Turn the switch a quarter turn clockwise.
Connect the connector to the switch.
Check the switch clearance.
| 6. CHECK BRAKE PEDAL FREE PLAY |
![]() |
Stop the engine. Depress the pedal several times until there is no vacuum in the booster. Then release the pedal.
Depress the pedal until resistance is felt.
Check the pedal free play by measuring the distance between the position in the previous step and the pedal's released position.
Check the switch clearance.
| 7. CHECK BRAKE PEDAL RESERVE DISTANCE |
Release the parking brake lever. Start the engine.
Depress the pedal and check the pedal reserve distance.
Depress the pedal with a force of 490 N (50 kgf, 110 lbf).
Measure the distance between the pedal and dash panel.
| Engine | VSC | LHD | RHD |
| 1AZ-FE | w/o | More than 90 mm (3.54 in.) | More than 80 mm (3.15 in.) |
| w/ | More than 115 mm (4.53 in.) | More than 105 mm (4.13 in.) | |
| 2AZ-FE | w/o | More than 95 mm (3.74 in.) | More than 85 mm (3.34 in.) |
| w/ | More than 120 mm (4.72 in.) | More than 110 mm (4.32 in.) | |
| 2GR-FE | w/ | - | More than 110 mm (4.32 in.) |
| 3ZR-FAE | w/o | More than 75 mm (2.95 in.) | More than 70 mm (2.76 in.) |
| w/ | More than 110 mm (4.33 in.) | More than 100 mm (3.94 in.) |
| 8. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY |
Install the instrument panel (Click here).
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |