Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the instrument panel (Click here).



3. DISCONNECT CONNECTORS
  1. Disconnect the stop light switch connector.

  1. with VSC:
    Disconnect the brake pedal load sensing switch connector.



4. REMOVE STOP LIGHT SWITCH ASSEMBLY
  1. Turn the switch counterclockwise and remove it.



5. REMOVE PUSH ROD PIN
  1. Remove the clip from the push rod pin.

  1. Remove the push rod pin from the push rod clevis.



6. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C129086E01
  1. Remove the bolt from the support.



    C126454
  1. Remove the 4 nuts and support.