FRONT BRAKE FLEXIBLE HOSE > INSTALLATION |
| 1. INSTALL FRONT FLEXIBLE HOSE |
![]() |
Connect the flexible hose with a new gasket and a new union bolt to the disc brake cylinder.
![]() |
Set the flexible hose clamp on the flexible hose bracket.
Simultaneously perform the following: 1) hang the hook part of the sensor clamp (labeled A) on the part of the flexible hose bracket (labeled C); and 2) insert the hook part of the sensor clamp (labeled B) to the part of the flexible hose bracket (labeled D).
![]() |
Tighten the bolt (labeled C) to fix the flexible hose clamp and sensor clamp.
Install the flexible hose with the bolt (labeled D).
Set the flexible hose to the connecting point with the brake tube (labeled A), and then attach a new clip (labeled B).
Using a union nut wrench, connect the flexible hose to the brake tube (labeled A) while holding the flexible hose with a wrench.
| 2. FILL RESERVOIR WITH BRAKE FLUID |
| 3. BLEED AIR FROM BRAKE MASTER CYLINDER |
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
Slowly depress and hold the brake pedal.
![]() |
Block the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
| 4. BLEED AIR FROM BRAKE LINE |

Remove the bleeder plug cap.
Connect the vinyl tube to the bleeder plugs.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.
When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.
Repeat the 2 previous steps until all the air in the brake fluid is gone.
Tighten the bleeder plug.
Install the cap.
Bleed air from the brake line for each wheel by repeating the above procedures.
| 5. BLEED AIR FROM BRAKE ACTUATOR ASSEMBLY (w/ VSC) |
Depress the brake pedal more than 20 times with the engine off.
Connect the intelligent tester to the DLC3, and turn the ignition switch on (IG).
Select AIR BLEEDING on the intelligent tester.
Bleed the air out of the suction line.
Connect a vinyl tube to the bleeder plug at the right front wheel or the right rear wheel.
Loosen the bleeder plug.
Operate the brake actuator to bleed the air using the intelligent tester.
Check if the operation has stopped by referring to the intelligent tester display.
Temporarily tighten the bleeder plug.
Repeat the 4 previous steps until all air in the fluid is completely bled out.
Tighten the bleeder plug.
Repeat all of the above procedures for the right rear wheel to bleed the air out of the suction line.
Bleed the air out of the pressure reduction line.
Connect a vinyl tube to either one of the bleeder plugs.
Loosen the bleeder plug.
Using the intelligent tester, operate the brake actuator assembly, completely depress the brake pedal and hold it there.
Tighten the bleeder plug, then release the brake pedal.
Repeat the 3 previous steps until all air in the fluid is completely bled out.
Tighten the bleeder plug.
Repeat all of the above procedures for the other wheels to bleed the air out of the pressure reduction line.
| 6. BLEED AIR FROM CLUTCH LINE (for Manual Transaxle) |
Fill the brake reservoir with brake fluid and bleed the clutch system.
| 7. CHECK BRAKE FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level and add fluid if necessary.
| 8. CHECK FOR BRAKE FLUID LEAKAGE |
| 9. INSTALL FRONT WHEEL |