Home › BRAKE › BRAKE › FRONT BRAKE FLEXIBLE HOSE

FRONT BRAKE FLEXIBLE HOSE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE FRONT FLEXIBLE HOSE


    C128557E01
  1. Disconnect the brake tube (labeled A) from the flexible hose with union nut wrench while holding the flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  1. Remove the clip (labeled B).

  1. Remove the 2 bolts (labeled C, D) and then remove the flexible hose clamp (labeled E) from the knuckle.



    C133753E02
  1. Remove the sensor clamp and flexible hose clamp from the flexible hose bracket.



    C127057
  1. Remove the union bolt and gasket, and then remove the flexible hose from the disc brake cylinder.