Home › BRAKE › BRAKE › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE REAR BRAKE TUBE FLEXIBLE HOSE


    C129063E01
  1. Disconnect the brake tube (labeled A) from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  1. Remove the clip (labeled B).



    C127076
  1. Remove the union bolt and gasket, and then remove the flexible hose from the disc brake cylinder.