Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING PANEL (for Manual Air Conditioning System)

AIR CONDITIONING PANEL (for Manual Air Conditioning System) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER


    B208365
  1. Using a moulding remover, detach the 3 clips and 2 claws, and then remove the cluster finish panel.

  1. Disconnect the connector.



3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER


    B208366
  1. Using a moulding remover, detach the 3 clips and 2 claws, and then remove the cluster finish panel.

  1. Disconnect the connector.



4. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)
  1. for 3ZR-FAE:
    Remove the radio receiver assembly with bracket .

  1. except 3ZR-FAE
    Remove the radio receiver assembly with bracket .



5. REMOVE STEREO OPENING COVER (w/o Radio Receiver)


B133002
  1. Remove the 4 bolts.

  1. Detach the 4 clips and remove the stereo opening cover.



6. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
  1. for DVD:
    Remove the navigation receiver assembly with bracket .

  1. for HDD:
    Remove the navigation receiver assembly with bracket .



7. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    E118688
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the 3 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors and remove the air conditioning control.



8. REMOVE AIR MIX CONTROL SWITCH


    E118685
  1. Detach the 2 claws and remove the air mix control switch.



9. REMOVE BLOWER CONTROL SWITCH


    E118686
  1. Detach the 2 claws and remove the blower control switch.



10. REMOVE AIR VENT MODE CONTROL SWITCH


    E118687
  1. Detach the 2 claws and remove the mode control switch.