Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    B256858
  1. Attach the 2 pins to install the roof wind deflector panel sub-assembly.

    NOTICE:
    B255591
    Check and be sure that the spring indicated by the arrow in the illustration is securely installed.



2. INSTALL SLIDING ROOF DRIVE CABLE


    B217955
  1. Hold down the roof wind deflector panel sub-assembly.



    B122192
  1. Using a screwdriver, slide the sliding roof drive cable sub-assemblies in the direction indicated by the arrow in the illustration to install them.

    HINT:
    1. Hold the roof wind deflector panel sub-assembly down until the sliding roof drive cable runs on the roof wind deflector panel sub-assembly.
    2. Tape the screwdriver tip before use.



    B125928
  1. Install the 2 sliding roof side stoppers with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



3. INSTALL REAR ROOF DRIP CHANNEL


B131978
  1. Move the rear roof drip channel forward from the rear side of the sliding roof housing, and install the rear roof drip channel to the sliding roof housing.

  1. Attach the 2 claws and install the rear roof drip channel.



4. ADJUST FULLY CLOSED POSITION


B084654E02
  1. Using a screwdriver, slide the sliding roof drive cable LH and RH to align the matchmarks.

    HINT:
    Tape the screwdriver tip before use.



5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


B133638E01
  1. Insert the sunshade trim into the sliding roof housing.



6. INSTALL SLIDING ROOF DRAIN HOSE JOINT LH


B129369
  1. Install the joint with the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



7. INSTALL SLIDING ROOF DRAIN HOSE JOINT RH

HINT:
Use the same procedures described for the LH side.



8. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


B125922
  1. Install the drive gear with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B125921
  1. Attach the claw and install the sliding roof drive gear bracket.