SLIDING ROOF SWITCH ASSEMBLY > INSPECTION |
| 1. INSPECT MAP LIGHT ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (UP) - 7 (GND) | TILT UP switch pushed | Below 1 Ω |
| 8 (UP) - 7 (GND) | TILT UP switch not pushed | 10 kΩ or higher |
| 9 (DOWN) - 7 (GND) | SLIDE OPEN switch pushed | Below 1 Ω |
| 9 (DOWN) - 7 (GND) | SLIDE OPEN switch not pushed | 10 kΩ or higher |