Home › BODY › SLIDING ROOF › SLIDING ROOF SWITCH ASSEMBLY

SLIDING ROOF SWITCH ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE MAP LIGHT ASSEMBLY


B129371
  1. Using a clip remover, detach the 4 clips and remove the light.

    HINT:
    Tape the clip remover tip before use.

  1. Disconnect the map light connector.