FUEL INJECTOR > INSTALLATION |
| 1. INSTALL FUEL INJECTOR ASSEMBLY |
![]() |
Apply a light coat of spindle oil or gasoline to 6 new O-rings, and install one to each injector.
![]() |
Apply a light coat of spindle oil or gasoline where the fuel delivery pipe contacts the O-ring.
Push the fuel injector while twisting it back and forth to install it in the fuel delivery pipe.
Position the fuel injector connector outward.
![]() |
Install 6 new insulators to the intake manifold.
![]() |
Place the fuel delivery pipe together with the 6 fuel injectors into the intake manifold.
![]() |
Temporarily install the 5 bolts which are used to hold the fuel delivery pipe to the intake manifold.
Tighten the 5 bolts which are used to hold the fuel delivery pipe to the intake manifold.
![]() |
Connect the 6 fuel injector connectors.
| 2. CONNECT FUEL MAIN TUBE |
![]() |
Push in the tube connector to the pipe until the tube connector makes a "click" sound.
Install the No. 2 fuel pipe clamp.
| 3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY |
Install the intake air surge tank assembly (Click here).
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT FOR COOLANT LEAK |
Remove the radiator reservoir cap.
![]() |
Fill the radiator with coolant, and then attach a radiator cap tester.
Warm up the engine.
Pump the radiator cap tester to 118 kPa (1.2 kgf/cm2, 17.1 psi), and then check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leakage.
If there are no signs of external coolant leaks, check the heater core, cylinder block and head.
Reinstall the radiator cap.
| 6. INSPECT FOR FUEL LEAK |