Home › ENGINE ยท 3ZR-FAE › STARTING › STARTER (for 1.3 kW Type)

STARTER (for 1.3 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    A264656
  1. Remove the nut and disconnect the lead wire from terminal C.



    A264657
  1. Remove the 2 screws and repair service starter kit from the drive housing.

  1. Remove the return spring and plunger from the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    A171330
  1. Remove the 2 through bolts and pull out the starter yoke together with the commutator end frame.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    A264659
  1. Remove the commutator end frame from the starter yoke.



4. REMOVE STARTER ARMATURE PLATE


    A083803E03
  1. Remove the armature plate from the starter yoke.



5. REMOVE STARTER COMMUTATOR END FRAME COVER


    A083801
  1. Using a screwdriver, remove the commutator end frame cover from the commutator end frame.



6. REMOVE STARTER ARMATURE ASSEMBLY
  1. Mount the commutator end frame in a vise between aluminum plates.

    NOTICE:
    Do not damage the commutator end frame.



    A264660
  1. Using snap ring pliers, remove the snap ring and plate washer.

    NOTICE:
    Do not drop the starter armature.

  1. Remove the starter armature from the commutator end frame.



7. REMOVE PLANET GEAR


    A171331
  1. Remove the 3 planet gears from the center bearing clutch.



8. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A073990
  1. Remove the center bearing clutch together with the drive lever set pin from the drive housing.

  1. Remove the drive lever set pin from the center bearing clutch.