STARTER (for 1.3 kW Type) > REASSEMBLY |
| 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
![]() |
Apply high-temperature grease to the drive lever set pin as shown in the illustration.
![]() | High-temperature Grease |
![]() |
Install the drive lever set pin to the center bearing clutch.
| *1 | Drive Lever Set Pin |
| *2 | Center Bearing Clutch |
Install the center bearing clutch together with the drive lever set pin to the drive housing.
| 2. INSTALL PLANET GEAR |
![]() |
Apply high-temperature grease to the planet gears and pin parts of the planet shaft.
![]() | High-temperature Grease |
Install the 3 planet gears to the pins of the planet shaft.
| 3. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Apply high-temperature grease to the plate washer, a new snap ring, and the bearing.
| *1 | Snap Ring |
| *2 | Plate Washer |
| *3 | Bearing |
![]() | High-temperature Grease |
![]() |
Apply high-temperature grease to the starter armature as shown in the illustration.
![]() | High-temperature Grease |
Install the starter armature to the commutator end frame.
Install the plate washer to the starter armature shaft.
Using snap ring pliers, install the snap ring.
Check the snap ring length.
![]() |
Using a vernier caliper, measure the snap ring length.
| *1 | Length |
| 4. INSTALL STARTER COMMUTATOR END FRAME COVER |
Install the commutator end frame cover to the commutator end frame.
| 5. INSTALL STARTER ARMATURE PLATE |
![]() |
Align the keyway of the armature plate with the key inside the starter yoke, and install the armature plate.
| *1 | Key |
| *2 | Keyway |
| 6. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY |
![]() |
Align the rubber part on the commutator end frame with the groove of the starter yoke.
| *1 | Rubber Part |
| *2 | Groove |
Install the commutator end frame to the starter yoke.
| 7. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Align the claw of the starter yoke with the groove inside the drive housing.
| *1 | Groove |
| *2 | Claw |
Install the starter yoke with the 2 through bolts.
| 8. INSTALL REPAIR SERVICE STARTER KIT |
![]() |
Apply high-temperature grease to the plunger and hook.
![]() |
Hang the plunger hook of the repair service starter kit on the drive lever set pin.
Install the plunger and return spring.
Install the repair service starter kit with the 2 screws.
Connect the lead wire to terminal C with the nut.