Home › ENGINE ยท 2GR-FE › ENGINE MECHANICAL › ENGINE ASSEMBLY

ENGINE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT INTAKE MANIFOLD


    A137423E01
  1. Using a precision straightedge and feeler gauge, measure the warpage of the contact surface of the cylinder head and intake air surge tank.

    Maximum warpage:
    Item
    Specified Condition
    Intake manifold side
    0.8 mm (0.031 in.)
    Cylinder head side
    0.2 mm (0.008 in.)

    If the warpage is greater than the maximum, replace the manifold.



2. INSPECT EXHAUST MANIFOLD


    A137425
  1. Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head for warpage.

    Maximum warpage:
    0.70 mm (0.0276 in.)

    If the warpage is greater than the maximum, replace the manifold.