Home › BODY › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE SWITCH BASE


    B209104
  1. Detach the 2 clips and 2 claws.

  1. Disconnect the connectors and remove the switch base.



3. REMOVE SEAT HEATER SWITCH


    B131376
  1. Using a screwdriver, detach the 2 claws and remove the switch.

    HINT:
    Tape the screwdriver tip before use.