Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2325    LIN Communication Bus Malfunction

for Preparation Click here


DESCRIPTION

DTC B2325 is output when the LIN communication line is abnormal inside the instrument panel junction block (main body ECU).

NOTICE:
When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn the courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.


DTC No.
DTC Detection
Trouble Area
B2325
LIN communication is abnormal inside instrument panel junction block (Main body ECU).
  1. Instrument panel junction block (Main body ECU)

INSPECTION PROCEDURE

1.CHECK DTC (DTC B2325)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Select the following menu items: Body / Main Body / DTC.

  1. Read DTCs.
    Result 
    Display (DTC output)
    Proceed To
    B2325
    A
    Other DTCs
    B
    No DTC output
    C



B
GO TO DTC CHART

C
SYSTEM IS NORMAL
A


2.READ VALUE USING INTELLIGENT TESTER (MAIN BODY ECU)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Main Body / Data List.

  1. Read the indication displayed on the tester.

    Main body ECU 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Communication D-Door Motor
    Connection status between power window regulator motor and main body ECU / OK or Stop
    OK: Connection
    Stop: No connection
    Communication Double Locking
    Connection status between double door lock ECU and main body ECU / OK or Stop
    OK: Connection
    Stop: No connection
    Communication Slide Roof
    Connection status between sliding roof ECU and main body ECU / OK or Stop
    OK: Connection
    Stop: No connection

    OK:
    OK is displayed on the intelligent tester screen.



OK
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
NG


3.RECHECK DTC (DTC B2325)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Select the following menu items: Body / Main Body / DTC.

  1. Read DTCs.
    Result 
    Display (DTC output)
    Proceed To
    B2325
    A
    No DTC output
    B



B
SYSTEM IS NORMAL
A

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)