Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2321    Driver Side Door ECU Communication Stop

for Preparation Click here


DESCRIPTION

DTC B2321 is output when the communication between the power window regulator motor (driver side) and main body ECU stops for more than 10 seconds.

NOTICE:
When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.


DTC No.
DTC Detection Condition
Trouble Area
B2321
No communication from power window regulator motor (driver side) for more than 10 seconds
  1. Power window regulator motor (driver side)
  2. Instrument panel junction block (Main body ECU)
  3. Wire harness

WIRING DIAGRAM


E124604E02


INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (DTC B2321)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Select the following menu items: Body / Body ECU / DTC.

  1. Result DTCs.
    Result 
    Display (DTC Output)
    Proceed to
    B2321
    A
    No DTC output
    B



B
SYSTEM IS OK
A


2.READ VALUE USING INTELLIGENT TESTER (COMMUNICATION D DOOR MOTOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Body ECU / Data List / Comm D-Door Mtr.

  1. Read the result displayed on the tester.

    Item
    Measurement Item / Display (Range)
    Normal Condition
    Communication D-Door Motor
    Connection status between power window regulator motor assembly (driver door) and main body ECU /
    OK or Stop
    OK: Connection
    Stop: No connection



OK
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
NG


3.CHECK WIRE HARNESS (MAIN BODY ECU - REGULATOR MOTOR)


    B124232E02
  1. Disconnect the H4*1 or G9*2 motor connector.

  1. Disconnect the E18 junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    for LHD:
    Tester Connection
    Specified Condition
    H4-9 (LIN) - E18-23 (LIN2)
    Below 1 Ω
    H4-9 (LIN) or E18-23 (LIN2) - Body ground
    10 kΩ or higher
    for RHD:
    Tester Connection
    Specified Condition
    G9-9 (LIN) - E18-23 (LIN2)
    Below 1 Ω
    G9-9 (LIN) or E18-23 (LIN2) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WHETHER DTC OUTPUT RECURS (DTC B2321)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Check whether DTC B2321 recurs 10 seconds or more after the ignition switch is turned on (IG).

    OK:
    No DTC is output.



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)