Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > IG Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the main power source supplied to the air conditioning amplifier when the ignition switch is turned on (IG). This power source is used for operating components such as the air conditioning amplifier.

WIRING DIAGRAM


E125193E01


INSPECTION PROCEDURE

HINT:
Start the engine before the inspection. Check the IG1 relay or battery if the engine does not start.

1.INSPECT FUSE (ECU-IG2)
  1. Remove the ECU-IG2 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY)
E123550E01
  1. Disconnect the E42 amplifier connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E42-14 (IG+) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BODY GROUND)
E123550E04
  1. Disconnect the E42 amplifier connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E42-24 (GND) - Body ground
    Bellow 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE