LIGHTING SYSTEM > Back-up Light Circuit |

| 1.INSPECT FUSE (GAUGE1) |
Remove the GAUGE1 fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.INSPECT BULB (BACK-UP LIGHT BULB) |
![]() |
Remove the rear combination light assembly.
Connect the positive (+) lead from the battery to terminal 6 and the negative (-) lead to terminal 1, then check that the bulb illuminates.
|
| ||||
| OK | |
| 3.CHECK TRANSAXLE TYPE |
| Transaxle Type | Proceed to |
| A/T | A |
| M/T | B |
|
| ||||
| A | |
| 4.INSPECT PARK / NEUTRAL POSITION SWITCH |
![]() |
Disconnect the B28 park / neutral position switch connector.
Measure the resistance of the switch.
| Tester Condition | Shift Position | Specified Condition |
| 2 (RB) - 1 (RL) | R | Below 1 Ω |
| 2 (RB) - 1 (RL) | Except R | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (PARK/NEUTRAL POSITION SWITCH - BATTERY) |
![]() |
Disconnect the B28 park / neutral position switch connector.
Measure the voltage of the wire harness side connector.
| Tester Condition | Condition | Specified Condition |
| B28-2 (RB) - Body ground | Ignition switch on (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 6.CHECK WIRE HARNESS (SWITCH - REAR COMBINATION LIGHT) |
![]() |
Disconnect the B28 park/neutral position switch connector.
Disconnect the K13 or K15 rear combination light connector.
Measure the resistance of the wire harness side connectors.
| Tester Condition | Specified Condition |
| B28-1 - K13-1 | Below 1 Ω |
| B28-1 - K15-1 | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 7.INSPECT BACK-UP LIGHT SWITCH |
![]() |
Disconnect the B25 back-up light switch connector.
Measure the resistance of the switch.
| Tester Condition | Shift Position | Specified Condition |
| 2 - 1 | R (Pushed) | Below 1 Ω |
| 2 - 1 | Except R (Not pushed) | 10 kΩ or higher |
|
| ||||
| OK | |
| 8.CHECK WIRE HARNESS (BACK-UP LIGHT SWITCH - BATTERY) |
![]() |
Disconnect the B25 back-up light switch connector.
Measure the voltage of the wire harness side connector.
| Tester Condition | Condition | Specified Condition |
| B25-2 - Body ground | Ignition switch on (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 9.CHECK WIRE HARNESS (BACK-UP LIGHT SWITCH - REAR COMBINATION LIGHT) |
![]() |
Disconnect the B25 back-up light switch connector.
Disconnect the K13 and K15 rear combination light connectors.
Measure the resistance of the wire harness side connectors.
| Tester Condition | Specified Condition |
| B25-1 - K13-1 | Below 1 Ω |
| B25-1 - K15-1 | Below 1 Ω |
|
| ||||
| OK | ||
| ||