IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK IGNITION COIL ASSEMBLY AND PERFORM SPARK TEST |
Check the DTCs.
Check that sparks occur.
Remove the No. 1 engine cover.
Remove the bolt and ignition coil.
![]() |
Using a 16 mm spark plug wrench, remove the spark plug.
![]() |
Disconnect the 4 fuel injector connectors.
![]() |
Install the spark plug into the ignition coil, and then connect the ignition coil connectors.
Ground the spark plug.
Check that sparks occur at the spark plug while the engine is being cranked.
Using a 16 mm plug wrench, install the spark plug.
Install the ignition coil with the bolt.
Connect the 4 fuel injector connectors.
Install the No. 1 engine cover.
Spark test flow chart.
Check that the ignition coil connector is securely connected.
| Result | Proceed to |
| NG | Connect securely |
| OK | Go to next step |
Perform the spark test on each ignition coil.
| Result | Proceed to |
| OK | Replace ignition coil |
| NG | Go to next step |
![]() |
Check the power supply to the ignition coil.
| Tester Connection | Specified Condition |
| 1 (+B) - 4 (GND) | 9 to 14 V |
| Result | Proceed to |
| NG | Check wire harness and connector |
| OK | Go to next step |
Check the resistance of the camshaft position sensor.
| Temperature Condition | Specified Condition |
| Cold | 835 to 1,400 Ω |
| Hot | 1,060 to 1,645 Ω |
| Result | Proceed to |
| NG | Replace camshaft position sensor |
| OK | Go to next step |
Check the resistance of the crankshaft position sensor.
| Temperature Condition | Specified Condition |
| Cold | 985 to 1,600 Ω |
| Hot | 1,265 to 1,890 Ω |
| Result | Proceed to |
| NG | Replace crankshaft position sensor |
| OK | Go to next step |
Check the IGT signal from the ECM.
| Result | Proceed to |
| NG | Check ECM (Click here) |
| OK | Repair wiring between ignition coil and ECM |
| 2. CHECK SPARK PLUG |
![]() |
Check the electrode.
Using a megohmmeter, measure the insulation resistance.
![]() |
Alternative inspection method:
Quickly accelerate the engine to 4,000 rpm 5 times.
Remove the spark plug.
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
| Manufacturer | Spark plug type |
| DENSO | SK20R11 |
| NGK | IFR6A11 |
![]() |
Check the spark plug electrode gap.
![]() |
Clean the spark plugs.
If the electrode has traces of wet carbon, clean the electrode with a spark plug cleaner and then dry it.