OIL FILTER > REPLACEMENT |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
| 2. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil drain plug and drain the oil into a container.
| 3. REMOVE OIL FILTER SUB-ASSEMBLY |
![]() |
Using SST, remove the oil filter.
| 4. INSTALL OIL FILTER SUB-ASSEMBLY |
Check and clean the oil filter installation surface.
Apply clean engine oil to the gasket of a new oil filter.
![]() |
Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.
Using SST, tighten the oil filter.
Depending on the work space available, choose from the following.
1. If enough space is available, use a torque wrench to tighten the oil filter.
| 5. ADD ENGINE OIL |
Clean and install the oil drain plug with a new gasket.
Add new oil.
| Item | Specified Condition |
| Drain and refill with oil filter change | 4.2 liters (4.4 US qts, 3.7 Imp. qts) |
| Drain and refill without oil filter change | 4.0 liters (4.2 US qts, 3.5 Imp. qts) |
| Dry fill | 4.9 liters (5.2 US qts, 4.3 Imp. qts) |
Install the oil filler cap.
| 6. CHECK FOR ENGINE OIL LEAKS |
| 7. INSTALL NO. 1 ENGINE UNDER COVER |