Home › ENGINE ยท 1AZ-FE › LUBRICATION › ENGINE OIL COOLER (w/ Oil Cooler)

ENGINE OIL COOLER (w/ Oil Cooler) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the cylinder block drain cock plug.


    A112179E01



3. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil drain plug and drain the oil into a container.



4. REMOVE OIL FILTER SUB-ASSEMBLY


    A124762E01
  1. Using SST, remove the oil filter.

    SST
    09228-06501  



5. REMOVE ENGINE OIL COOLER
  1. Disconnect the 2 oil cooler hoses from the oil cooler.



    A124387
  1. Remove the union bolt, nut, plate washer, oil cooler and O-ring.