LUBRICATION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait for 5 minutes.
Check that the engine oil level is between the L and F marks, of the oil dipstick.
If low, check for leakage and add oil up to the F mark.
| 2. CHECK ENGINE OIL QUALITY |
Check the oil for deterioration, water intrusion, discoloration or thinning.
If the quality is visibly poor, replace the oil.

| 3. CHECK OIL PRESSURE |
Disconnect the oil pressure switch connector.
![]() |
Using a 24 mm deep socket wrench, remove the oil pressure switch.
![]() |
Install the oil pressure gauge.
Warm up the engine.
Measure the oil pressure.
| Condition | Specified Condition |
| Idle | 29 kPa (0.3 kgf/cm2, 4.3 psi) or more |
| 3,000 rpm | 245 to 539 kPa (2.5 to 5.5 kgf/cm2, 36 to 78 psi) |
![]() |
Apply adhesive to 2 or 3 threads of the oil pressure switch.
Using a 24 mm deep socket wrench, install the oil pressure switch.
Connect the oil pressure switch connector.
Check for engine oil leakage.