Home › ENGINE ยท 2AZ-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait for 5 minutes.

  1. Check that the engine oil level is between the L and F marks of the oil dipstick.
    If low, check for leakage and add oil up to the F mark.

    NOTICE:
    Do not add engine oil above the F mark.



2. CHECK ENGINE OIL QUALITY


  1. Check the oil for deterioration, water intrusion, discoloration or thinning.
    If the quality is visibly poor, replace the oil.

    Oil grade:
    20W-50 and 15W-40 API grade SL or SM multigrade engine oil 10W-30 and 5W-30 API grade SL "Energy-Conserving", SM "Energy-Conserving" or ILSAC multigrade engine oil



    A112498E09



3. CHECK OIL PRESSURE
  1. Disconnect the oil pressure switch connector.



    A112272
  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.



    A112273E01
  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard oil pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.3 psi) or more
    3,000 rpm
    160 to 539 kPa (1.6 to 5.5 kgf/cm2, 23 to 78 psi)



    A085603E02
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or Equivalent

  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour of installation.

  1. Connect the oil pressure switch connector.

  1. Check for engine oil leakage.