Home › ENGINE ยท 1AZ-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL FAN AND GENERATOR V BELT


    A114351E01
  1. Using SST 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then install the fan and generator V belt.

    SST
    09216-42010  

    NOTICE:
    1. Be sure to connect SST and the tools so that they are in line during use.
    2. When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
    3. After the tensioner is fully retracted, do not apply force any more than necessary.



2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
  1. Install the reinforcement RH with the 4 bolts.

    Torque:
    96 N*m{ 989 kgf*cm , 71 ft.*lbf }



3. INSTALL FRONT FENDER APRON RH


4. INSTALL FRONT WHEEL RH


5. INSTALL RADIATOR SUPPORT OPENING COVER