TIMING CHAIN > INSPECTION |
| 1. INSPECT NO. 1 CHAIN TENSIONER |
![]() |
Check that the plunger moves smoothly when the ratchet pawl is raised with your finger.
Release the ratchet pawl, then check that the plunger is locked in place by the ratchet pawl and does not move when pushed with your finger.
| 2. INSPECT CHAIN SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the length of the 16 links with the chain fully stretched.
| 3. INSPECT NO. 2 CHAIN SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the length of the 8 links with the chain fully stretched.
| 4. INSPECT CHAIN TENSIONER SLIPPER |
![]() |
Using a vernier caliper, measure the tensioner slipper wear.
| 5. INSPECT NO. 1 CHAIN VIBRATION DAMPER |
![]() |
Using a vernier caliper, measure the vibration damper wear.
| 6. INSPECT CRANKSHAFT TIMING SPROCKET |
![]() |
Wrap the chain around the timing sprocket.
Using a vernier caliper, measure the timing gear diameter with the chain.
| 7. INSPECT OIL PUMP DRIVE SPROCKET |
![]() |
Wrap the chain around the drive sprocket.
Using a vernier caliper, measure the drive gear diameter with the chain.
| 8. INSPECT OIL PUMP DRIVE SHAFT SPROCKET |
![]() |
Wrap the chain around the drive shaft sprocket.
Using a vernier caliper, measure the drive shaft gear diameter with the chain.