Home › ENGINE ยท 2AZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE RADIO SETTING CONDENSER


    A112227
  1. Remove the bolt and condenser.



2. REMOVE OIL PRESSURE SWITCH


    A114362
  1. Using a 24 mm deep socket wrench, remove the sensor.



3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A114367E01
  1. Using SST, remove the sensor and gasket.

    SST
    09817-33190  



4. REMOVE CAMSHAFT POSITION SENSOR


    A114368
  1. Remove the bolt and sensor.



5. REMOVE NO. 2 CAMSHAFT BEARING


    A013383E01
  1. Remove the No. 2 camshaft bearing.



6. REMOVE NO. 1 CAMSHAFT BEARING


    A114361
  1. Remove the No. 1 camshaft bearing.



7. REMOVE VALVE LIFTER

HINT:
Arrange the valve lifters in the correct order.



8. REMOVE INTAKE VALVE
  1. Place the cylinder head on wooden blocks.



    A098132E01
  1. Using SST, compress the spring, then remove the 2 retainer locks.

    SST
    09202-70020   (09202-00010)



    A114364E01
  1. Remove the retainer, spring and valve from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



9. REMOVE EXHAUST VALVE
  1. Place the cylinder head on wooden blocks.



    A098133E01
  1. Using SST, compress the spring, then remove the 2 retainer locks.

    SST
    09202-70020   (09202-00010)



    A114363E01
  1. Remove the retainer, spring and valve from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



10. REMOVE VALVE SPRING SEAT


    A014192E01
  1. Using compressed air and a magnetic finger, remove the spring seat by blowing air.

    HINT:
    Arrange the valves, valve springs, spring seats and spring retainers in the correct order.



11. REMOVE VALVE STEM OIL SEAL


    A013356E01
  1. Using needle-nose pliers, remove the 16 oil seals.