CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL VALVE STEM OIL SEAL |
![]() ![]() |
Using SST, push in a new oil seal.
| 2. INSTALL INTAKE VALVE |
Place the cylinder head on wooden blocks.
![]() |
Install the valve, seat, spring and retainer onto the cylinder head.
![]() |
Using SST, compress the spring, and place the 2 retainer locks around the valve stem.
![]() |
Using a plastic-faced hammer and discarded valve (with its tip wrapped with tape), lightly tap the installed valve to fit it into place.
| 3. INSTALL EXHAUST VALVE |
Place the cylinder head on wooden blocks.
![]() |
Install the valve, seat, spring and retainer onto the cylinder head.
![]() |
Using SST, compress the spring, and place the 2 retainer locks around the valve stem.
![]() |
Using a plastic-faced hammer and discarded valve (with its tip wrapped with tape), lightly tap the installed valve to fit it into place.
| 4. INSTALL VALVE LIFTER |
Assemble the valve lifter and the tip of the valve stem with a light coat of engine oil applied.
| 5. INSTALL NO. 1 CAMSHAFT BEARING |
Clean the contact surfaces of the bearing and the bearing cap.
![]() |
Align the bearing claw with the claw groove of No. 1 and No. 2 bearing cap, and push in the No. 1 camshaft bearing.
| 6. INSTALL NO. 2 CAMSHAFT BEARING |
Clean the contact surfaces of the bearing and the cylinder head.
![]() |
Install the No. 2 camshaft bearing onto the cylinder head.
| 7. INSTALL CAMSHAFT POSITION SENSOR |
![]() |
Install the sensor with the bolt.
| 8. INSTALL ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Install a new gasket and the ECT sensor.
| 9. INSTALL ENGINE OIL PRESSURE SWITCH |
Apply adhesive to 2 or 3 threads of the oil pressure switch.
![]() |
Install the oil pressure switch.
| 10. INSTALL RADIO SETTING CONDENSER |
![]() |
Install the condenser with the bolt.