Home › BODY ELECTRICAL › METER › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B129872
  1. Using a screwdriver, detach the 4 clips, 6 claws and remove the instrument cluster finish panel.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE COMBINATION METER ASSEMBLY


B136780
  1. Remove the 2 screws.

  1. Pull the combination meter as indicated by the arrow in the illustration to detach the 2 clips.

  1. Disconnect the connector and remove the combination meter.