Home › ENGINE ยท 1AZ-FE › EMISSION CONTROL › EMISSION CONTROL SYSTEM

EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FUEL CUT RPM


    A124804
  1. Increase the engine speed to at least 3,500 rpm.

  1. Use a sound scope to check for injector operating noise.

  1. Check that the operating sounds stop momentarily and then resume when the throttle lever is released.

    HINT:
    Measure with the A/C OFF.

    Fuel return rpm:
    1,400 rpm



2. CHECK FOR LEAKS


    B011449E01
  1. Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

    NOTICE:
    1. Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose and other components may cause the engine to run improperly.
    2. Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.

    If the result is not as specified, replace parts as necessary.



3. CHECK CANISTER


    A182969E02
  1. Close port C, apply compressed air to port A and check that air flows out from port B.
    If the result is not as specified, replace the fuel suction plate sub-assembly.



    A182970E02
  1. Close port C, apply compressed air to port B and check that air flows out from port A.
    If the result is not as specified, replace the fuel suction plate sub-assembly.



    A182971E02
  1. Apply compressed air to port B and check that air flows out from port A and port C.
    If the result is not as specified, replace the fuel suction plate sub-assembly.



    A182972E02
  1. Close ports A and C, and apply compressed air to port B to check for leaks.
    If the result is not as specified, replace the fuel suction plate sub-assembly.