Home › ENGINE ยท 2GR-FE › EMISSION CONTROL › EMISSION CONTROL SYSTEM

EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FUEL CUT RPM
  1. Increase the engine speed to at least 3500 rpm.

  1. Use a sound scope to check for injector operating sounds.

  1. Check that the operating sounds stop momentarily and then resume when the throttle lever is released.

    HINT:
    Perform this step with the A/C off.

    Fuel injection restart rpm:
    1400 rpm



2. INSPECT FOR LEAK


    A094394E01
  1. Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

    NOTICE:
    1. Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose and other components may cause the engine to run improperly.
    2. Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.

    If any defects are found, replace parts as necessary.



3. CHECK CANISTER


    A182969E02
  1. Close port C, apply compressed air to port A and check that air flows out from port B.
    If the result is not as specified, replace the fuel suction plate sub-assembly.



    A182970E02
  1. Close port C, apply compressed air to port B and check that air flows out from port A.
    If the result is not as specified, replace the fuel suction plate sub-assembly.



    A182971E02
  1. Apply compressed air to port B and check that air flows out from port A and port C.
    If the result is not as specified, replace the fuel suction plate sub-assembly.



    A182972E02
  1. Close ports A and C, and apply compressed air to port B to check for leaks.
    If the result is not as specified, replace the fuel suction plate sub-assembly.