EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL CUT RPM |
![]() |
Increase the engine speed to at least 3,500 rpm.
Use a sound scope to check for injector operating noise.
Check that the operating sounds stop momentarily and then resume when the throttle lever is released.
| 2. CHECK FOR LEAKS |
![]() |
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
| 3. CHECK CANISTER |
![]() |
Close port C, apply compressed air to port A and check that air flows out from port B.
If the result is not as specified, replace the fuel suction plate sub-assembly.
![]() |
Close port C, apply compressed air to port B and check that air flows out from port A.
If the result is not as specified, replace the fuel suction plate sub-assembly.
![]() |
Apply compressed air to port B and check that air flows out from port A and port C.
If the result is not as specified, replace the fuel suction plate sub-assembly.
![]() |
Close ports A and C, and apply compressed air to port B to check for leaks.
If the result is not as specified, replace the fuel suction plate sub-assembly.