Home › ENGINE ยท 2GR-FE › EMISSION CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE AIR FUEL RATIO SENSOR (for Bank 2)
  1. Disconnect the air fuel ratio sensor connector.



    A173720E01
  1. Using SST, remove the air fuel ratio sensor (for bank 2) from the exhaust manifold.

    SST
    09224-00010  



2. REMOVE NO. 2 EXHAUST PIPE SUB-ASSEMBLY (for Bank 1)
  1. Remove the 2 bolts and 2 nuts.

  1. Remove the No. 2 exhaust pipe sub-assembly from the 3 exhaust pipe supports.



  1. Remove the gasket.


    A173724



3. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for Bank 1)


  1. Remove the 2 bolts, 2 nuts, and center exhaust pipe assembly.


    A173725

  1. Remove the 2 gaskets.



4. REMOVE NO. 1 FRONT EXHAUST PIPE SUPPORT BRACKET (for Bank 1)
  1. Remove the 2 bolts and No. 1 exhaust pipe support bracket.



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Bank 1)
  1. Remove the 2 bolts and No. 1 exhaust pipe support bracket.



6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Bank 1)
(Click here)


7. REMOVE MANIFOLD STAY (for Bank 1)


    A171613
  1. Remove the 2 bolts, nut and manifold stay.



8. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH (for Bank 1)
  1. Disconnect the air fuel ratio sensor connector clamp.



    A133291
  1. Uniformly loosen and remove the 6 nuts.

  1. Remove the manifold and gasket.



9. REMOVE AIR FUEL RATIO SENSOR (for Bank 1)


    A173784E01
  1. Using SST, remove the air fuel ratio sensor (for bank 1).

    SST
    09224-00010