Home › ENGINE ยท 1AZ-FE › EMISSION CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


A124801E01
  1. Using SST, install the sensor to the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure SST and wrench are connected in a straight line.

  1. Connect the sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


3. CHECK FOR EXHAUST GAS LEAKS