Home › ENGINE ยท 3ZR-FAE › EMISSION CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


A209092E01
  1. Using SST, install the sensor to the center exhaust pipe.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.).
    2. Make sure SST and wrench are connected in a straight line.



    A209827E01
  1. Connect the sensor connector.



2. INSTALL FRONT FLOOR COVER


    A209090
  1. Install the floor under cover with the 3 clips, bolt and nut.

    Torque:
    for bolt:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }
    for nut:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



3. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
  1. Install the rear console box sub-assembly (Click here).



4. INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.